- Radius and Angle dresser is a positive setting of the diamond to absolute center with the special gage included with the dresser.
- Radius is set on the grinder by measuring over the two pins or by inserting a gage block, as shown, for direct reading.
- Radius and Angle Dresser Inside or outside radius are determined simply by sliding the dowel pin to the V-TDB vertex is up for concave and down for convex.
- Vertex Radius and Angle dresser are giving a 4-90º graduation in full 360º circle.
- Radius and Angle dresser is 6 Minute Vernier reading.
- One push-pull type knob for radius and angle control and safer and faster operations.
- Extremely close tolerances are held in the manufacture of this tool, assured by hardening and precision grinding of all critical parts.
- Vertex V-TDB Ways are chrome hardened.
- Set-up and dressing time reduced to a bare minimum due to simplicity.
Related products
